Gripon Pro traction control with USB interface and software
 Traction control with wheel sensors for Ducati models

Traction control with two wheel sensors, which detect the front and rear wheel speed and use with engine speed and throttle position to calculate the control algorithms.
Thus, the wheel speed is directly recorded and processed with the throttle position and engine speed record in contrast to other systems which only increase the engine speed with wheel spin.

The adjustment is done by software on the PC or laptop through a USB port.

Vehicle-related basic parameters:
Wheel size front and rear
Number of Sensor Pickups (disc screws)
Firing signal (number of ignitions per crankshaft revolution)

Entering this configuration allows quick adaptation to almost all motorcycle models and a precise control of the response

The adjustment to the driver may be using the following parameters:
three basic levels (Amateur, Normal and Professional)
individual adjustment of the effect within this level
three different throttle valve opening areas
gradual increase in the action based on the Wheel Spin (MTC algorithm)
Wheelie Control

can be stored on the device and may be switched while driving through a remote control switch on the handlebars up to two maps (accessories must be ordered separately).

The withdrawal of the service can be the
Ignition (a spark plug)
Injection (injectors on a plug)

. Done The wiring harness for the ignition is pre-ready and allows quick installation on all common Aprilia models (for other vehicles, please use the relevant item numbers).

The wheel sensors must be installed on the vehicle itself. If desired, the cultivation also in our home for € 250, - at a flat rate.
Simple metal bracket satisfy the sensor with 1.5 to 2.5 mm from the disc screws of the front or rear wheel to install (see picture, the holders are not included).
The sensor cable can be removed from the sensor to facilitate Radausbau.
Similarly, several vehicles can be equipped with sensors and cables, it must use only the control unit to be reconnected, the traction control can be.

By the included handlebar switch the traction control can be while driving on and off.

Here are the facts:
Weight 350 g
Case size approx 87 x 56 x 30 mm
Power consumption on standby less than 80 mA
Sensor thread M8 x 20
Sensor cable length 200 cm per sensor
not tied to the tire size
regardless of the ratio
German manual is